Aluminum Composite Panels are popular external cladding products that are widely used in modern architecture and buildings. They are also used as the internal surface designing and coating material.
To ensure that these products fit correctly into the design of the construction, they need to be fabricated precisely and then installed in various methods. Almost all of the methods utilized in the industry for this purpose are approvable. Before installing ACM panels, some prior action needs to be taken, considering thermal contraction and extraction, removing the protective film, and defining the process direction.
Change of temperature can lead the ACP fasteners into intolerable overstressing and bowing. Thus, to avoid this type of damage, heating the construction work and ambient air process must be considered. It is essential to know that aluminum composite panel has a coating system , damaged if the temperature exceeds centigrade degrees.
This means that the thermal resistance of the material must be modified before installation. Thus, removing the protective film as soon as the material reaches the construction site is necessary. After the removal, it is essential not to use a marker pen or tape on the coated surface.
Particles such as acrylic, rubber, and epoxy can be very harmful to coating integrity. It is crucial to install the ACP materials in the predefined direction, whether horizontal or vertical.
Manufacturers apply the paint finish in one consistent order. Thus, for maintaining the finish and the color across the panels, each ACM panel must course in the correct direction. Identifying the path is not so hard. The protective films are being developed, having an arrow on them, which defines the proper installing order and the applied finish.
For proper ventilation, the system must be installed with offset clips at every fastening point, which, aside from providing this essential ventilation, will allow for minor adjustments to compensate for slight inconsistencies in the substrate; keeping the panel faces on the same plane. Upon arrival of your order, inventory and inspect each panel and all accessories, and note any damage to panels, packaging, or accessories.
If there are any signs of damage, note the bill of lading at the time of delivery. Failure to do so can make it difficult to file a freight claim. Bailing bands are to be removed upon delivery. Lift the panels from each stack individually, taking care not to scratch or damage any adjacent panels when removing panels from the stack. Panels can be stored vertically on a flat surface free of debris, or kept on pallets with supports at 12 inches on center or less.
All horizontal surfaces, including panels and pallets, should be covered with a clean membrane or board to protect the panels from damage.
Unwrapped stacks should be covered with plastic sheeting in order to minimize damage from dirt and moisture. Remember to remove bailing bands prior to storage. Panels need to be stored in an area that is well covered from the elements, cool, ventilated, and dry.
Pay close attention to the direction of the material during installation and field fabrication. The majority of ACM material is directional; that is, during manufacturing the paint is applied to the composite material in one consistent direction. Most ACM materials have arrows on the protective film that show which direction the finish was applied.
Remember, all panels need to be installed in the same direction throughout a project unless intentionally noted otherwise. To avoid scratching the panel finish, all cutting, routing, and drilling should be performed from the backside of the ACM material. ACM consists of two layers of.
Both materials are fairly easy to cut and route. Rivet; 3. Angel Aluminum; 4. Angel Aluminum; 5. Padding; 6. Silicon sealant; 7. Spacer; 8. External Panel:. Sealer; 3. Padding; 4. Angel Steel; 5. Steel plate strip. Angel support; 3. Steel strip; 4. Sealer; 5. Bullen screw; 7. Bearing strut; Steel angel. Internal Corner:. Steel angel; 5. The clearance between two aluminum composite panel shall be handled internally to make it flat and bare.
Cover the part which prones to contamination with plastic film or other material after finishing the installation. Jinxiang is a world-famous aluminum composite panel manufacturer. Feel free to contact us if you are interested in aluminum composite panel related products.
0コメント